Features

  • Single-channel NO/NC switching

    A five-pin changeover relay provides normally open and normally closed contacts for one load circuit.

  • 817C optocoupler

    The control input uses an 817C optocoupler.

  • Status indication and coil protection

    An onboard LED indicates output status, and a flyback diode suppresses the voltage spike from the relay coil.

  • Screw-clamp terminals

    Separate screw terminal blocks secure the control wires and the load wires.

  • Compact mounting footprint

    The black PCB measures 56.5 × 16.8 × 20 mm overall and has four mounting holes.

Overview

3 V DCNominal relay coil voltage
1 channelRelay output
NO / NCContact options
15 gProduct weight

BESTEP 3 V relay module

This black-PCB module pairs a JQC3F-03VDC-C changeover relay with an 817C optocoupler. Separate terminal blocks provide access to the control input and the relay contacts.

Front view of the BESTEP relay module showing the relay markings and both terminal blocks

Screw terminals and mounting holes

The board has a three-position screw terminal block at each end and a mounting hole at each corner.

Angled view of the BESTEP relay module showing the screw-clamp terminals Top view of the black PCB showing both terminal blocks and four mounting holes

Operating Precautions

Disconnect power from both circuits before wiring. The values printed on the relay housing apply to the relay contacts. Verify the complete assembly and the actual load, including inrush current, before use.

Specifications

BrandBESTEP
Module typeSingle-channel optocoupler relay module
Nominal relay coil voltage3 V DC
Relay markingJQC3F-03VDC-C
Contact configurationSPDT (COM, NO, NC)
Relay contact ratings shown on housing10 A at 250 V AC / 125 V AC, 10 A at 30 V DC / 28 V DC
Optocoupler marking817C
Control terminalsVCC, IN, GND
Response time (stated)<20 ms
Dimensions (L × W × H)56.5 × 16.8 × 20 mm
Product weight15 g

Package Contents

  • 1 × BESTEP 3 V single-channel optocoupler relay module

FAQ

What is the difference between NO and NC?

With the coil de-energized, COM is connected to NC. When the coil energizes, COM switches to NO.

What does the 3 V specification refer to?

It is the nominal relay coil voltage. The load circuit has its own supply and switches through the relay contacts.

Connection & Operating Notes

The control terminal block is labeled VCC, IN, and GND. Check the input trigger level and current requirements before connecting a controller.

Close-up of the control terminals labeled VCC, IN, and GND